Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
16 years ago

Cyclone III active parallel (AP) configuration supported flash

In the thread "using numonyx p33 tsop for ciii ap config"(i am unable to post the link) proposed support for the new 65nm Numonyx flash memories was indicated to be supported by november 2009. ...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
16 years ago

I have the same problem. I have an evaluation kit design in production that sticks close to Altera's Cyclone III Starter Board design. When Numonyx PC28F256P30B85 was obsolete its replacement was PC28F256P30BFA. Numonyx was recently acquired by Micron, and I don't know what the equivalent Micron replacement part is.

Mark