Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
16 years ago

Configuration / Initialization issues CYCLONE III custom board

Hi, We made our custom board with CYCLONE III FPGA (EP3C16Q240) and memories [SdRam, Nand flash and serial flash (ST's MT25P16)] with only few interfaces [VGA, SD Card and Ethernet] The bo...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
16 years ago

Hi,

conf_done FPGA pin of my custom board is connected to the base of NPN transistor via 1K resistor, After connecting this via 10K resistor , FPGA entered User mode and FPGA is working as expected.

Regards,

Jagadeesh.B