Forum Discussion
Todd2
New Contributor
New ContributorCannot configure EPCQ256 component on Cyclone V E FPGA development board
Purchased this board from Terasic, but they have no solution for this issue, suggested I submit here. Trying to program the EPCQ256 QSPI device on the Cyclone V E FPGA dev. board. Schematic notes a...
YuanLi_S_Intel
Regular Contributor
Regular ContributorWhat was the previous board setting that you have?
You may use command line to do programming via JTAG. Please take a look at the quartus_pgm command in user guide:
https://www.intel.com/programmable/technical-pdfs/654662.pdf
Can you try to turn SW2.4 to on and SW2.3 to off?
