Forum Discussion

Todd2's avatar
Todd2
Icon for New Contributor rankNew Contributor
3 years ago

Cannot configure EPCQ256 component on Cyclone V E FPGA development board

Purchased this board from Terasic, but they have no solution for this issue, suggested I submit here. Trying to program the EPCQ256 QSPI device on the Cyclone V E FPGA dev. board. Schematic notes a...
YuanLi_S_Intel's avatar
YuanLi_S_Intel
Icon for Regular Contributor rankRegular Contributor
3 years ago

Can you check if the device part number selected in Quartus is 5CEFA7F31I7N? Also if the MSEL is in active serial mode?


Todd2's avatar
Todd2
Icon for New Contributor rankNew Contributor
3 years ago

The device part number selected in Quartus is 5CEFA7F31I7. See attached screen captures.

I configured MSEL as 10010 (Fast Active Serial) and 10011(Standard Active Serial) and I still get the same error message. See attached

screen capture of the Programming Message window.

Thanks for any help you can provide.

Todd