Forum Discussion

Todd2's avatar
Todd2
Icon for New Contributor rankNew Contributor
3 years ago

Cannot configure EPCQ256 component on Cyclone V E FPGA development board

Purchased this board from Terasic, but they have no solution for this issue, suggested I submit here. Trying to program the EPCQ256 QSPI device on the Cyclone V E FPGA dev. board. Schematic notes a...
YuanLi_S_Intel's avatar
YuanLi_S_Intel
Icon for Regular Contributor rankRegular Contributor
3 years ago

Can you check if the device part number selected in Quartus is 5CEFA7F31I7N? Also if the MSEL is in active serial mode?


  • Todd2's avatar
    Todd2
    Icon for New Contributor rankNew Contributor
    3 years ago

    The device part number selected in Quartus is 5CEFA7F31I7. See attached screen captures.

    I configured MSEL as 10010 (Fast Active Serial) and 10011(Standard Active Serial) and I still get the same error message. See attached

    screen capture of the Programming Message window.

    Thanks for any help you can provide.

    Todd