arria gx development board output port

Question

I'm an FPGA green hand. I wanna use the Arria GX development board to generate 3 singals to control the movement of a probe. I don't know how can I do this, and how can I connect the signals to the target? since I didn't find any output ports on the board. :confused:

Hope I can get some useful help.

Thanks!

altera_forum · Answer

You have to use a daughter board of type GPIO-HSMC, like this: http://www.terasic.com.tw/cgi-bin/page/archive.pl?language=english&categoryno=67&no=218

Thus you can access the IOs of HSMC connector of Arria Gx kit.

altera_forum · Answer

Thank you very much!  Can I connect the AD/DA data conversion card to the arria gx devlopment board?

altera_forum · Answer

Yes. It's possible.

Forum Discussion

arria gx development board output port

3 Replies

Recent Discussions

DK-DEV-AGI027-RA QSPI Verification Fails

Cyclone 5 SoC FPGA Bank Supply Prerequisite

AGILEX 5 Migration issue

To INTEL - Request for Compliance Data from Analog Devices, Inc

Arria 10 GX RX max intra-differential pair skew