Using Cypress SPI Flash to configure Arria II GX device

Question

I'm interested in using a Cypress SPI Flash memory to configure an Arria II GX FPGA.   I've read that some earlier versions of Quartus check the device ID before programming.  The Device ID check fails for Cypress SPI Flash Memory.  Is that still the case with Quartus Prime v19 and v20?

yuanli_s_intel · Answer

Hi Hai,Apologize that it is not with v19 and v20. You may check our 3rd party flash support at link below:https://www.intel.com/content/www/us/en/products/programmable/configuration-device.htmlThank You.Regards,Bruce

hsteg · Answer

Thanks Bruce.Hal

Forum Discussion

Using Cypress SPI Flash to configure Arria II GX device

2 Replies

Recent Discussions

Agilex™ 7 FPGA M-Series Development Kit_HBM2e Edition_REVB2_Altera

Agilex 7 R-Tile PIPE Direct endpoint receives Set_Slot_Power_Limit, but no Config TLPs

SyncE clock as the reference for DDR, HBM, and FPGA control interfaces in the Agilex M-Series design

R-tile CXL base hard IP example for the Agilex 7 M-series Dev Kit (DK_DEV_AGM039EA) does not work

PCIe Root Complex on DK-A5E013BM16AEA