New ContributorHi, I'm currently using De10 lite FPGA interfacing with 16-bit ADC to take voltage measurement. After some processing the output would be 32 bits and i would send it to pc and view it on labview. Is there any possible way i can send thedata to the pc using jtag uart of the fpga. I had zero knowledge on how to configure the jtag. Is there any pointers where i should start?
Frequent ContributorHi MHafi3,
You need to instantiate the UART IP in your design. You may refer to below reference design to see how we implement UART in our design:
Let me know if you need further clarification.
Thanks
New ContributorHi ShafiqY_Intel ,
Thank you for replying.
Currently im able to display data from my vhdl code to NIOS 2 processor by instantiate PIO and JTAG UART and view it on nios2 terminal through stdout command. Is there any method that i can use to transfer the data to labview via serial ?. My DE10-lite board only have JTAG_UART interface to connect to the host pc.
Frequent ContributorHi MHafi3,
I don't think we have your request method in implementation in our design example website.
We apologize for any inconvenience we may have caused you
Thanks
