Forum Discussion
JFrye2
New Contributor
New ContributorProgramming CycloneV FPGA from U-Boot SPL
I have a DE1-SoC board from Terasic. I am trying to boot a Linux kernel that can talk to the hardware in the FPGA portion. I am trying to verify that my FPGA is programmed during the boot cycle. I am...
thanhtungNew Contributor
New Contributorhi @JFrye2,
I'm following the same guide and De1-SoC as you. But after I create img and use putty boot it on board, nothing happens like the below photo. So could you tell me Did you do anything other than what is in the guide? And what value of MSEL did you use? that is [00000] or [01010]?
Thank you so much!
