Forum Discussion

HIngl1's avatar
HIngl1
Icon for New Contributor rankNew Contributor
7 years ago

Open Cl on De10 nano Development board

Hello,

I am following the manual from the link

Link1- https://www.terasic.com.tw/cgi-bin/page/archive.pl?Language=English&CategoryNo=205&No=1046&PartNo=4

for this-"BSP(Board Support Package) for Intel FPGA SDK OpenCL 18.1"

according to the manual i require Quartas standard edition for running Open CL and create a folder in the installation location of it

but the shown image in the manual has folders which are related to Quartas pro, which dosent support the Open Cl

Please Guide me further

Thanks

3 Replies

  • Hiroto_K_Intel's avatar
    Hiroto_K_Intel
    Icon for New Contributor rankNew Contributor
    7 years ago

    Hello,

    Which image did you point out ? Please let me know the figure number.

    • HIngl1's avatar
      HIngl1
      Icon for New Contributor rankNew Contributor
      7 years ago

      File name -DE10_Nano_OpenCL_18.1.pdf , Page -12,Figure 2-1- Location of "D;\intelFPGA\18.1\hld\board\terasic" Folder

      the path is for Quartas 18.1 pro , but the open CL here dosent support the pro edition of Quartas it supports only the Standard edition .

      • Hiroto_K_Intel's avatar
        Hiroto_K_Intel
        Icon for New Contributor rankNew Contributor
        7 years ago

        The default root path of current standard version is D\intelFPGA and that of pro version is D\intelFPGA_pro. Additionally, the directory hierarchy under root is same.

        Also, if the directory was for pro version, there would be a10_ref and s10gx(not c5soc/s5_ref).

        Thus, I think the path(D;\intelFPGA\18.1\hld\board\terasic) is correct.