Forum Discussion
matif
Occasional Contributor
Occasional ContributorLinux boot successful but FPGA not configured from soc_system.rbf file
My Linux image is able to boot successfully the problem is that my FPGA is not able to be configured from my fpga raw binary file that I have copied to fat partition of my sd card. I have tried all the SW6 settings with all the compressed and uncompressed FPP, AX configuration files but fpga is not configuring. Any suggestions on what can I do?
1 Reply
EBERLAZARE_I_IntelRegular Contributor
Hi,
Which board are you using? Arria 10, Cyclone V, etc?
You can refer here for the FPGA configuration:
https://rocketboards.org/foswiki/Documentation/GSRDProgrammingFPGA
Here for the particular boards:
https://rocketboards.org/foswiki/Documentation/GSRD
Regards.
