Forum Discussion

fpga_nick's avatar
fpga_nick
Icon for New Contributor rankNew Contributor
7 months ago

Did I need to set a proper pin assignment if I running a simulation ?

I am trying to run a design example simulation for AGIB027R29A1E2VR3, F-tile. Quartus version v23.3 , Questasim 2023-2. But the target devkit with proper pin selection only available for F-series...
Board Debug
Fpga Devkit
RichardT_altera's avatar
RichardT_altera
Icon for Super Contributor rankSuper Contributor
7 months ago

Any update on this?

Do you able to resolve your simulation problem?


Regards,

Richard Tan