Forum Discussion

qwitza's avatar
qwitza
Icon for Occasional Contributor rankOccasional Contributor
9 months ago

Cyclone 5 first boot linux crashes, howto debug?

Hello, We have a design with a Cyclone V FPGA. Some boards only boot after a reset following power-on. Problem: The Debian Linux with U-Boot boots from the SD card, but after approximately 10 seco...
Board Debug
Fpga Devkit
tehjingy_Altera's avatar
tehjingy_Altera
Icon for Regular Contributor rankRegular Contributor
6 months ago

Hi


Did you managed to try out the "dd" command to flash the FPGA configuration?

We should not use the overlay method as it is not catered for the CycloneV device.


Regards

Jingyang, Teh