Forum Discussion
qwitza
Occasional Contributor
Occasional ContributorCyclone 5 first boot linux crashes, howto debug?
Hello, We have a design with a Cyclone V FPGA. Some boards only boot after a reset following power-on. Problem: The Debian Linux with U-Boot boots from the SD card, but after approximately 10 seco...
tehjingy_Altera
Regular Contributor
Regular ContributorHi
Could you change the rpd to partial?
It would need to be partial as the full configuration could cause the HPS to reconfigured too.
When the HPS is configured the linux running will alsoo crashes, I believe what is happening currently in your case.
Regards
Jingyang, Teh
qwitzaOccasional Contributor
Occasional ContributorHello,
i think we can not change to partial, because we have only the free version.
i am right?
greetings
