Configuration Flash Memory For Cyclone IV E - Military Grade?

Also, initially you said that I can only use ASx1 mode, but seems that now you are saying that I should use QSPI. Are you saying that QSPI can be setup in ASx1 mode?

Hi,

I am sorry to tell you we do not have flash device that is able to support automotive grade. I would recommend you to use MT25QL device from Micron or other vendor that has automotive grade Serial NOR Flash device.

Hi JohnT_intel,

Thank you, yes, I would have loved to stay with Intel on this part, but I'm happy that there are possibly other options so that I can still proceed with the Cyclone IV E.

Regards...

Can you please tell me if MT25QL is compatible with the Cyclone IV E, and if Quartus Prime Standard will recognize it.

The reason I ask is because in the past, I tried to use a Flash memory from another company and I tried programming the configuration into the device in Quartus using a USB Blaster II, and had some issues recognizing the ID of the memory.

Also, can you indicate whether I can use AS mode with any of their chips?

Thanks for you responses!

Hi,

It should be able to work but it can only support ASx1. Please refer to https://www.intel.com/content/www/us/en/programmable/support/support-resources/knowledge-base/component/2018/how-do-i-enable-micron-s-mt25q-support-for-eol-of-epcq---256mb--.html on how to enable it. Please follow the step which is the same as Cyclone 10 LP device.

Hi,

We do not have schematic or documentation for Cyclone IV but you may still follow the configuration connection based on Cyclone 10 LP (https://www.intel.com/content/dam/altera-www/global/en_US/support/boards-kits/cyclone10/c10lp-eval-a1-sch.PDF - page 4). The testing is not being tested on Cyclone IV as it is a old device but it should be possible.

Hi,

Thanks for your response!

The schematic doesn't use MT25QL memory, but EPCQ128A.

I'm already familiar with the EPCQ128A because I already used it in other projects.

What I'm looking for is a schematic which uses MT25QL, to see how it is connected up to the FPGA.

Can you please provide an example for MT25QL & Cyclone 10, which may give me some guidance on drawing up my schematic?

Thank you,

Hi,

Unfortunately, I do not have the schematic for this. You can still connect it based on how QSPI interface connection.

Hi JohnT,

Thanks for that.

So are the parts I chose compatible and I can do QSPI interface?:

Cyclone IV E &

MT25QL256ABA8E12-0AUT

Is Quad-SPI parallel and not serial?

What I've done for the last two projects is to use one 10-pin connector to program the flash as well as interface to the FPGA using the a module instantiated inside the FPGA for AS mode.

That way, I can program through the FPGA via AS mode.

Can you please point me in the right direction for documenation, and provide some information on how to connect up QSPI to the FPGA?

Also, how do I set things up in the FPGA HDL to utilize QSPI?

Please elaborate, so that I can gain a better understanding and move forward.

Thanks again for your help...

Here is my attempt at comparing the pins of the Intel flash with Micron's, does this look correct and what should I do with the other pins in blue (see attached image file)?

Can you please expedite a response ?

Thanks,