foisal
New Contributor
New ContributorXADC simulation
Is it possible to simulate Xilinx XADC in Questa Sim 10.6_1 simulator? I like to instantiate the XADC module in the top-level testbench module to overserve the temperature or voltage value.
Forum Discussion
2 Replies
SyafieqSSuper Contributor
Hi Ahmed,
Assuming you want to run Questa independently, I would yes. If no, I don't think so.
Are you running Intel FPGA Questa in Xilinx environment? Xilinx should have their own simulation tools to be ran from their side. If you want to run Xilinx design in Intel FPGA, You first need to do migration before you can do any simulation, you can look into the document here on how to do the migration: https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/an/an307.pdf
Look for area:
3. FPGA Tools Comparison 4. Xilinx to Intel FPGA Design Conversion
After that, you can just launch the Questa mention in
3.3.12. Simulation
- SyafieqS
We do not receive any response from you to the previous reply that I have provided, thus I will put this case to close pending. Please post a response in the next 15 days to allow me to continue to support you. After 15 days, this thread will be transitioned to community support. The community users will be able to help you with your follow-up questions.
