Forum Discussion

Richard_P's avatar
Richard_P
Icon for New Contributor rankNew Contributor
3 years ago

Error when running u-boot using Arm DS debugger on Arria 10 Dev Kit

Hi, I am getting an error when trying the load and run u-boot through the Arm Development Studio debugger on my Arria 10 Dev-Kit. I am using this Arria 10 Han Pilot Dev kit sold through Terasic: h...
Hps Boot
aikeu's avatar
aikeu
Icon for Regular Contributor rankRegular Contributor
3 years ago

Hi Richard_P,


We do not receive any response from you to the previous question/reply/answer that I have provided. This thread will be transitioned to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you.


Thanks.

Regards,

Aik Eu


R_G's avatar
R_G
Icon for New Contributor rankNew Contributor
2 years ago

Hi Aik,

I apologize for the late response. I would like to activate this thread if possible. I don't have any logs from when the preloader is executed. I don't get any output from the serial terminal while the preloader executes even though it should be there. It seems like the preloader and uboot build is not getting configured correctly from the handoff xml file of the Han Pilot default dev kit design when following the Rocketboards instructions for building the bootloader. The Han Pilot board has 1GB DDR4 on board memory just like the Intel Arria 10 dev kit. Can you replicate this error on the Intel Arria 10 dev kit if you have access to one?

Thanks,

Richard