Forum Discussion

paulgeisler's avatar
paulgeisler
Icon for New Contributor rankNew Contributor
3 days ago

BSP generation for I2C

How do I get the BSP generator to generate code for the I2C that I added into the platform of the max10? It generates code for the JTAG but not the I2C. I made sure that I connected the SDA and SCL lines to external pins. See three screenshots.

general

3 Replies

  • umut_arrow's avatar
    umut_arrow
    Icon for Occasional Contributor rankOccasional Contributor
    2 days ago

    Hi,

    Firstly, your csr isn't connected looking at the screenshot of Platform Designer. Also you need to set the I2C IP to Avalon-MM Slave, instead of Avalon-ST.

    Lastly, I think you need to make sure your SDA/SCL pins are wired correctly. 

    I'm assuming you're following the Nios V tutorial, since your project is named AN 985. Take a look at Avalon I2C host core documentation as well, specifically "I2C Serial Interface Connection" section. SDA_IN and SDA_OE both should be connect to a bi-directional open-drain buffer, same as SCL_IN and SCL_OE.

  • ai_responder's avatar
    ai_responder
    Icon for Community Manager rankCommunity Manager
    3 days ago

    Thank you for your inquiry. To ensure an accurate response, your request has been routed to an Altera application engineer for further review and assistance.


    Note: To continue using AI Responder, please start your next inquiry with ai_responder

    Disclaimer (Beta): The AI Responder is currently provided as a beta feature. AI-generated responses may contain errors or omissions. Please verify technical guidance with official Altera documentation before implementation.

    Thank you very much.