Forum Discussion

raju1421's avatar
raju1421
Icon for Occasional Contributor rankOccasional Contributor
3 years ago

[Agilex]: Programming & Flashing FPGA File (.jic) to QSPI Flash from HPS through ethernet

Hi all, I have been using the below mentioned guide for porting u-boot and linux on agilex board Building Bootloader for Agilex 7 | Documentation | RocketBoards.org But, there is no information ab...
FvM's avatar
FvM
Icon for Super Contributor rankSuper Contributor
3 years ago

Hello,

.jic (JTAG indirect programming file) is intended for programming through JTAG only. Programming through HPS should use flash image file (e.g. .rpd) and ASMI parallel II or generic flash interface IP in FPGA.

Regards,

Frank

raju1421's avatar
raju1421
Icon for Occasional Contributor rankOccasional Contributor
3 years ago

Hi @FvM ,

Thanks for the response.

We are using (.sof) file and (u-boot-spl-dtb.hex) file to generate (.jic) file.

Please provide us the steps to generate (.rpd) file for Agilex EMMC Booting.

Thanks & Regards

Raju S