Forum Discussion

FPGA_user2's avatar
FPGA_user2
Icon for New Contributor rankNew Contributor
2 years ago

Unable to get LED blink on the FPGA board Cyclone V 5CGXFC5C6F27C7N

Hello everyone, I am doing an LED blink program using the FPGA board Cyclone V 5CGXFC5C6F27C7N. I am sharing the Verilog code, .sdc file, and the pin assignment screenshots. LED Blink code...
Hdl
AqidAyman_Altera's avatar
AqidAyman_Altera
Icon for Regular Contributor rankRegular Contributor
2 years ago

Based on your last question on the steps you followed, in the first step, you no need to choose the board since you are using custom board. You just choose the FPGA device OPN that the board is using.


Then, can you tried to reprogram the device using the programmer?


  • FPGA_user2's avatar
    FPGA_user2
    Icon for New Contributor rankNew Contributor
    2 years ago

    Sir,

    Thank you for your reply.

    I have selected only the FPGA device OPN that the board uses in the first step. I tried to reprogram, but there was no result.

    Regards