Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
14 years ago

the value of burstcount signal

Hi everyone, I'm new to Qsys, and I have a naive question about burstcount signal: What's the value of burstcount when the typical read and write transfer(not burst transfers) is used? Is it ...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
14 years ago

--- Quote Start ---

That is correct, to drive a signal beat transaction you post a burst count of 1. If you don't plan on using bursting then you don't need to include the burst count signal.

--- Quote End ---

Thanks for you reply.

I did't find this point in Avalon Interface Specification, could you show me some references?

regards,

zhangfeng