Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
18 years ago

Specify voltage on input pins

Hi All, I am using a Cyclone 3 development board. I will be implementing a circuit with 6 input and 4 output pins. I have written the code, compiled and run simulations of the circuit, but now ...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
18 years ago

scanseer (http://www.scanseer.com), a software for 'manual' boundary-scan, can help you. Scanseer allows to manipulate with values on pins when chip is in INTEST mode -- to test chip internal logic; and in EXTEST mode -- to test PCB interconnections.

+ the software is very nice and easy to use.