Forum Discussion

Honored Contributor

11 years ago

re-configure altera cyclone 4 device when in user mode

Hi , My question is i want to re-configure altera cyclone 4 device when in user mode. So, i have implemented logic to drive nCONFIG pin. But when i assign my design output to nCONFIG pin it giv...

Altera_Forum

Honored Contributor

11 years ago

nCONFIG can't be driven from user logic as far as I'm aware of. You can force a reconfiguration by using the remote_update block, as recently discussed in this thread

http://www.alteraforum.com/forum/showthread.php?t=45057&p=190385#post190385

Forum Discussion

re-configure altera cyclone 4 device when in user mode

Recent Discussions

How to fix Error(23782): Failed to find an expected report

Quartus 22.1 and 23.1 Synthesis Error

Connection bit order between hierarchy

Could not link 'vsim_auto_compile.dll' error troubleshooting.

Failed to run ip-setup-simulation: