Quartus Prime Lite compatibility with bladeRF 2.0 micro xA9

Question

I want to be able to use Quartus Prime lite in a pilot Project to develop a customized Cyclone V image for the Nuand bladeRF 2.0 micro xA9 development board. (https://www.nuand.com/product/bladeRF-xA9/). This device uses the Cyclone V SoC.

Is this board compatible/supported by Quartus Prime lite? Can I use VHDL or Verilog in this effort without requiring a license?

Has anyone here used the Quartus Prime lite suite with the Nuand bladeRF 2.0 micro xA9 development board with success?

The pilot Project is aimed at verifying usability and programmability as respect both this hardware and the Quartus Prime software as a basis for moving forward into the full Quartus suite.

shengn_altera · Answer

Hi,Yes, this board is compatible/supported by Quartus Prime lite. And you can use VHDL or Verilog in this effort without requiring a license because Quartus Prime lite don't requires a license.As for bladeRF 2.0 micro xA9 development board programming part, may be you can open a new thread in FPGA, SoC, And CPLD Boards And Kits forum https://community.intel.com/t5/FPGA-SoC-And-CPLD-Boards-And/bd-p/fpga-soc-cpld-boards-kits to get related expert's help.Thanks,Best Regards,Sheng

william_stroupe · Answer

Thanks so much, Sheng!

Forum Discussion

Quartus Prime Lite compatibility with bladeRF 2.0 micro xA9

2 Replies

Recent Discussions

Is Quartus Prime Pro 22.4 Compatible with Stratix 10 NX Series Device?

Timing analysis - long combinational path

QuartusPro 25.3 Crashed after using the Signal Tap Logic Analyzer

Duplicate_hierarchy_depth / duplicate_register

Automatically added negative node for TDS output doesn't work with Agilex 5