Quartus 10.1 Waveform Editor back?

This pdf was enough for me to figure it out

ftp://ftp.altera.com/up/pub/altera_material/9.1/tutorials/verilog/modelsim_gui_introduction.pdf (http://ftp//ftp.altera.com/up/pub/altera_material/9.1/tutorials/verilog/modelsim_gui_introduction.pdf)

It's not a perfect match and the interface is less intuitive than the waveform editor in 9.1 .

If you want to rerun a simulation then you need to do simulate ->run->restart

I haven't figured out how to stop modelsim from duplicating signals when you save the waveform and reload it at a later date.

HTH