Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
11 years ago

Programming HPS pins in Quartus II - Unused HPS Pins

Dear community, On my PCB design, most of the HPS pins are unused - according to the pin connection guidelines, I should either 'Connect unused pins as defined in the Quartus II software' (for ...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
11 years ago

Hi Adam,

--- Quote Start ---

  1. When I create a preloader with the bsp-editor (launched via the SoC EDS 14.0 Command Shell), how do I incorporate the information from Quartus about the pins?

--- Quote End ---

in my understanding, this information is in the "hand-off files" which are generated by Quartus in the assembler phase. (Therefore it is important to run Quartus after a change in Qsys that affects the preloader.)

Regards,

Thomas

www.entner-electronics.com - Home of EEBlaster