Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
14 years ago

Programing 5M80ZE64C5N MAX V CPLD

Hi, I'm getting this error when I try to program the 5M80ZE64C5N MAX V CPLD: Info: Started Programmer operation at ... Info: Device 1 contains JTAG ID code 0x020A50DD Error: Can't recogn...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
14 years ago

Hi Dave,

Yes, it was a big relief for me.

Although, sometimes the programming fails at half the percentage, but if I put my finger on the IC it resolves =D (not in the manual =P)

Yes, I resorted to the manual at different stages of the project, but I didn't read it all :

Once again big thank you

Kind regards

Pedro Ferreira