Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
14 years ago

Programing 5M80ZE64C5N MAX V CPLD

Hi, I'm getting this error when I try to program the 5M80ZE64C5N MAX V CPLD: Info: Started Programmer operation at ... Info: Device 1 contains JTAG ID code 0x020A50DD Error: Can't recogn...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
14 years ago

--- Quote Start ---

In the design layout I didn't supply voltage to the bank 2 leaving their pins in air. Should I supplied it?

--- Quote End ---

Did you read the handbook?

http://www.altera.com/literature/hb/max-v/max5_handbook.pdf

Try reading section 4. Hint ...

"All VCCINT and VCCIO power supplies of all banks must be powered on before entering user mode"

Cheers,

Dave