Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
14 years ago

Programing 5M80ZE64C5N MAX V CPLD

Hi, I'm getting this error when I try to program the 5M80ZE64C5N MAX V CPLD: Info: Started Programmer operation at ... Info: Device 1 contains JTAG ID code 0x020A50DD Error: Can't recogn...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
14 years ago

Hi,

Any ideas? I still can't program my Max V, and I'm out of ideas.

In the design layout I didn't supply voltage to the bank 2 leaving their pins in air. Should I supplied it?

I have 3.3V on VCCINT and 1.8V on VCCIO1, and with each vcc pin I put a 100nF decoupling cap. The development board has 2 x 100nF and a 10uF in parallel, per VCC Pin.

Does anyone has been successful programing 5M80ZE64C5N CPLD? Or any other MAX V CPLD besides the development board that has an incorporated USB-Blaster?

If so, does anyone has a *.pof program file designed for 5M80ZE64C5N CPLD for me to program?

So I can put aside the cause from the software and focus on the hardware.

Kind regards

Pedro Ferreira