Forum Discussion
Occasional ContributorPower Analyzer for Cyclone 10 GX
OK, you're talking about the PTA for early power estimates, not the Power Analyzer within Quartus (used to be referred to as "Powerplay") that provides a final power analysis of your design after compilation which supports all devices supported by that edition of Quartus. Neither the PTA nor the older PTC support Cyclone 10 GX.
For early power estimates for Cyclone 10 GX, you have to use the appropriate early power estimator (EPE) spreadsheet:
https://www.altera.com/design/resource/power/epe-and-pa
Super ContributorOK, you're talking about the PTA for early power estimates, not the Power Analyzer within Quartus (used to be referred to as "Powerplay") that provides a final power analysis of your design after compilation which supports all devices supported by that edition of Quartus. Neither the PTA nor the older PTC support Cyclone 10 GX.
For early power estimates for Cyclone 10 GX, you have to use the appropriate early power estimator (EPE) spreadsheet:
https://www.altera.com/design/resource/power/epe-and-pa
KennyT_alteraJust to add: For initial estimates, use the EPE spreadsheet for Cyclone 10 GX, and once your design is compiled in Quartus, you can use the Power Analyzer for more accurate, design-specific results.
