Forum Discussion

JPrig's avatar
JPrig
Icon for Occasional Contributor rankOccasional Contributor
30 days ago
Solved

Power Analyzer for Cyclone 10 GX

Hi, I work on a project for Cyclone 10 GX. I would like to estimate current consumption per voltage based on the actual VHDL code and later based on actual simulation results. Power Analyzer inside ...
Simulation
  • sstrell's avatar
    sstrell
    26 days ago

    OK, you're talking about the PTA for early power estimates, not the Power Analyzer within Quartus (used to be referred to as "Powerplay") that provides a final power analysis of your design after compilation which supports all devices supported by that edition of Quartus.  Neither the PTA nor the older PTC support Cyclone 10 GX.

    For early power estimates for Cyclone 10 GX, you have to use the appropriate early power estimator (EPE) spreadsheet: 

    https://www.altera.com/design/resource/power/epe-and-pa

sstrell's avatar
sstrell
Icon for Super Contributor rankSuper Contributor
27 days ago

What makes you think it's not supported?

https://docs.altera.com/r/docs/683174/current

JPrig's avatar
JPrig
Icon for Occasional Contributor rankOccasional Contributor
26 days ago

because I get this error message when I attempt to start the Power Analyzer and Cyclone 10 GX is not on the list.

 

  • KennyT_altera's avatar
    KennyT_altera
    Icon for Super Contributor rankSuper Contributor
    20 days ago

    Do you have further queries? If no, we shall close this thread. 

    • JPrig's avatar
      JPrig
      Icon for Occasional Contributor rankOccasional Contributor
      20 days ago

      Thanks, you can close this thread.