Forum Discussion

JPrig's avatar
JPrig
Icon for Occasional Contributor rankOccasional Contributor
4 months ago
Solved

Power Analyzer for Cyclone 10 GX

Hi, I work on a project for Cyclone 10 GX. I would like to estimate current consumption per voltage based on the actual VHDL code and later based on actual simulation results. Power Analyzer inside ...
Simulation
  • sstrell's avatar
    sstrell
    4 months ago

    OK, you're talking about the PTA for early power estimates, not the Power Analyzer within Quartus (used to be referred to as "Powerplay") that provides a final power analysis of your design after compilation which supports all devices supported by that edition of Quartus.  Neither the PTA nor the older PTC support Cyclone 10 GX.

    For early power estimates for Cyclone 10 GX, you have to use the appropriate early power estimator (EPE) spreadsheet: 

    https://www.altera.com/design/resource/power/epe-and-pa

sstrell's avatar
sstrell
Icon for Super Contributor rankSuper Contributor
4 months ago

What makes you think it's not supported?

https://docs.altera.com/r/docs/683174/current

  • JPrig's avatar
    JPrig
    Icon for Occasional Contributor rankOccasional Contributor
    4 months ago

    because I get this error message when I attempt to start the Power Analyzer and Cyclone 10 GX is not on the list.

     

    • KennyT_altera's avatar
      KennyT_altera
      Icon for Super Contributor rankSuper Contributor
      4 months ago

      Do you have further queries? If no, we shall close this thread. 

      • JPrig's avatar
        JPrig
        Icon for Occasional Contributor rankOccasional Contributor
        4 months ago

        Thanks, you can close this thread.