Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
17 years ago

Output Pins stuck at VCC or GND

Hi all. I've just finished writing and simulating a program which functions as a calculator.. However upon compiling the program, there is this warning which says: "Output Pins stuck at VCC or ...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
14 years ago

I'm having a bit of a problem with this myself.

I'm trying to drive output pins with a constant driver in a couple of procedures. I also have a state machine where in it's first state, the output pins are all connected to ground. After it's first state (The init state) it shouldn't be tied to ground anymore!