Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
17 years ago

Output Pins stuck at VCC or GND

Hi all. I've just finished writing and simulating a program which functions as a calculator.. However upon compiling the program, there is this warning which says: "Output Pins stuck at VCC or ...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
16 years ago

Thanks for paying attention to.The warnings are not complete.Here is another important one.

Warning: No paths found for timing analysis