Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
17 years ago

Output Pins stuck at VCC or GND

Hi all. I've just finished writing and simulating a program which functions as a calculator.. However upon compiling the program, there is this warning which says: "Output Pins stuck at VCC or ...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
17 years ago

Hi,

since you haven't yet assigned then don't worry(the fitter felt free and chose to tie them up to vcc). Once you drive your outputs then the fitter will obbey your assignment.

The fitter actually follows default (unused pins assignment)