ModelSim simulator

Question

Hi,

I am new to ModelSim, so I hope you can help.

I have a design (VHDL) I try to simulate in ModelSim. A have made a VWF and exported it to a testbench. I have enabled the Native link options. In the Testbenches I have added the file, but when I make a simulation er get some errors:

# ** Warning: [4] C:/altera/70/quartus/Designs/ASIC_Touchsensor/Version1/Data_Parsed4.vht(174): (vcom-1207) An abstract literal and an identifier must have a separator between them.

# ** Error: C:/altera/70/quartus/Designs/ASIC_Touchsensor/Version1/Data_Parsed4.vht(174): near "40": expecting: IDENTIFIER

Can anyone tell me what that means?

Also can anyone point to some tutorials about ModelSim?

Regards,

altera_forum · Answer

See the following native-link example, see if it helps. http://www.altera.com/support/examples/ncsim/exm-ncsim-native-link.html

altera_forum · Answer

Hi

I am trying to run the native-link example above.

When ModelSim runs it suddenly shuts down. It happens when the do-file comes to either the VSIM command or ADD wave * command.

Does anybody know why this happens?

Regards,

altera_forum · Answer

For the#  "add wave *" comand. When you run simulate &gt;start simulation, do not choose the "Enable optimization". I use the modesim 6.5c .

Forum Discussion

ModelSim simulator

3 Replies

Recent Discussions

Failing IO buffer

Perpetual license Quartus II doesn't allow to build Cyclone V devices anymore.

Unable to Enrol into SSLC Due to Microsoft Authentication App Issue

Repeat of a Questa License Issue

How can my company retrieve a license for Quartus Prime Standard 15.1?