Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
12 years ago

Just wiring two pins together

I'm sure this is a really easy answer, but I haven't been able to find it. Some signals were sent through my CPLD, someone thinking I might want to mess with them, and I don't for now, I just want t...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
12 years ago

Thanks Dave-

Does it make a difference if I don't want to connect to the 'bus' (Which is just point to point with one master and one slave) I have no interest in reading the signals, but a board has already been laid out, with the signals being routed through my device. If I could hold both pins in a high Z state, and jumper the pins together with a wire, or PCB trace, that would work fine, what I am trying to do is really just a wire between two pins.

Best Regards