Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
17 years ago

I/O pins Pull-Up Resistors

Hello, I am designing an embedded board with the MAX II EPM240T100C5N device. I am going to use some of the pins on the device to drive Output pins and to read Input pins. I would like to kno...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
11 years ago

Hello,

this is an old thread but it seems to match what I am looking for.

I'd like to enable pull-up resistors on a MAX3000 device (EPM3064A). The Pin Planner in Quartus 13.0 sp1 does not show me any of the context options of 8.0 above. Can anybody point me in the right direction how to emable pull-up resistors for inputs? Either in QuartusII or in the Verilog source file.

Also how do you set low power mode for the macro cells?

Kind Regards