Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
14 years ago

Error Code: 8 for command

Hello, I'm trying to burn the example "count binary" code into CFI flash on the cyclone III starter board. I'm getting the error, "Error code: 8 for command: nios2eds/bin/nios2-flash-pr...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
12 years ago

Hi All,

I have the same problem, but in a little bit different situation. I am using DE2 board with Cyclone II FPGA. The university program SoPC extension supports the flash controller IP core. I have built my design and the flash programmer started to work but finally it stopped with the same error. Could you help in that case? Address[0] virtual assignment did not help. I have attached pictures about the system.

Thanks&Regards,

Zsolt