Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
14 years ago

Error Code: 8 for command

Hello, I'm trying to burn the example "count binary" code into CFI flash on the cyclone III starter board. I'm getting the error, "Error code: 8 for command: nios2eds/bin/nios2-flash-pr...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
14 years ago

Hi All,

Thanks for all the info concerning the flash. I see this is an old thread so I don't know if anyone will see this but it seems like the best place for it.

I have a stratix III dev kit, and I was wondering if anyone has had success building a qsys system for this board. The flash part on the board is the 512P30 part. I've followed instructions posted earlier, but so far haven't had any luck. I've tried both the generic tristate controller, and the older CFI component which then is upgraded though the SOPC to QSYS upgrade. Any ideas?

Thanks so much for your help.