--- Quote Start ---
Hi, pletz.
Thank you for your advise. I have followed the Timing Advisor and selected the "All paths". Maybe it is because that I used a gated clock and I did not constrain it. And so the gated clock has a relatively large skew if it drives registers via non-global clock dedicated routing resource?
--- Quote End ---
Hi,
you can check whether the output of your clock gating is implemented as global.
Look into the report:
Fitter -> Resource section -> Gobal & other fast signals
If not and you have some global lines left you can assign the output of the gating cell to global by using the assignment editor.
Kind regards
GPK
Honored Contributor
