Forum Discussion
New ContributorVirtual UFM included in HW summary and bsp but pof file does not reflect increased space.
v18.1 tools, Nios II/e device: 10M16DCU324
uncomressed single image. Qsys configured for CFM2 as virtual-UFM (read-write) and memory map includes increased space. Code (.text) not carrying across into the new increased space. Map file from pof conversion still shows only UFM0+UFM1.
How do I get CFM2 to show up as part of the full UFM space?
The issue has been identified. It was an incorrect device on the development HW: a 10M16DCU324 was installed while a 10M16DAU324 or 10M16DFU324 should have been installed.
The 'DC' does not support virtual-UFM in the CFM sectors. Doh!
2 Replies
Ahmed_H_Intel1Frequent Contributor
Hi,
Please check the following pages that will help you to understand the requirements and steps available:
.pof and ICB Settings: https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/hb/max-10/ug_m10_config.pdf#page=37
https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/hb/max-10/ug_m10_config.pdf#page=7
Regards,
- MPETE26
The issue has been identified. It was an incorrect device on the development HW: a 10M16DCU324 was installed while a 10M16DAU324 or 10M16DFU324 should have been installed.
The 'DC' does not support virtual-UFM in the CFM sectors. Doh!
