Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
21 years ago

uart communication

I am running a 1S10 board and freestanding application to communicate over an RS232 cable to a PC. I have a GUI running on a PC sending about a 30 Hz status message that expects a NIOS response but t...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
21 years ago

So, what I was hoping for was "sure, just re-initialize the UART and it will work fine". But nobody is saying that. Holding off the master is not an option - devices will be transmitting when the NIOS is coming up. I am using the freestanding approach.

Any other ideas?