Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
20 years ago

Processor not responding

I have the Cyclone II DSP Development Kit (2C35 device) but cannot get my "hello world" program to run. I always get the following message. Using cable "USB-Blaster [USB-0]", device 1, instanc...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
20 years ago

Hi,

I have just the same problem and I don't use any standard hardware. So you can calm down, and focus on other topics as just on the SD-RAM thing on your board. It must be a problem with the IDE.

If I find the problem, I'll post soon.

Good luck, I hope someone will find the solution and will post it.

Bye