Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
20 years ago

Processor not responding

I have the Cyclone II DSP Development Kit (2C35 device) but cannot get my "hello world" program to run. I always get the following message. Using cable "USB-Blaster [USB-0]", device 1, instanc...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
20 years ago

Hello,

I was trying to run the board diag project on the standard for DE2 board and getting the similar problem. I didn't recompile the standard project but used the .sof file for programmer only and I think that should be ok (I don't need to recompile unless I want to add more hardware with the SOPC Builder right?). So I don't think error in compilation would result in this problem of processor not responding.

I tried several ways to overcome this but still didn&#39;t work. Any help would be very appreciated http://forum.niosforum.com/work2/style_emoticons/<#EMO_DIR#>/smile.gif

Thanks.