Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
15 years ago

Problems debugging simple program in NIOS II IDE

Hardware and software tools: NIOS II IDE 10.1 ("Legacy") Quartus II 10.1 Device:Arria II GX - EP2AGX260FF35I5N I am using software tools and hardware as described and a custom board.When ...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
15 years ago

--- Quote Start ---

If you are sure about sopc system and pin assignments, then it is probably a timing problem.

--- Quote End ---

I do it on Cyclone IV,it's OK;but on Stratix III 340, it does'n.

I wonder to know if Stratix III 340 has special standard.

I use Quartus10.1 and Nios Eclipse