problem running eth0

Hi all,

I´m trying to run Linux MMU with Altera TSE on a custom board with Vitesse VSC8601 Phy.

I ckecked "Drivers for Vitesse Phy" and "Altera Triple Speed Ethernet Mac Support" in menuconfig and built the image.

During boot everything seems to be ok, but when I start eth0 with command "ifconfig eth0 up", following error occurs:

0:12 not found

eth0: Could not attach to Phy

...

Is it because of a wrong value in phy_addr in config.c?

Do I have to make changes in vitesse.c because of VSC8601 Phy?