Forum Discussion
Altera_Forum
Honored Contributor
Honored Contributorprob. in accessing UART
Hello ... i have written the following prog. to access my uart in my design it is named as "uart_0" in the SOPC builder.... while running this prog. in NIOSII IDE i was simulataneously running...
Altera_ForumHonored Contributor
Honored Contributor --- Quote Start --- originally posted by pfab@Nov 29 2005, 05:54 AM ->niosii ide to run the code in cyclone kit
is this a development board from altera?
->using the project "accessing memory" present in sls corporation site
i am not familiar with sls corporation. if you give a link to their webpage i can check on the project you mentioned.
--wolf
<div align='right'><{post_snapback}> (index.php?act=findpost&pid=11233)
--- quote end ---
--- Quote End --- hello Mr.WOLF thanks again for ur patient following of my mails .. yes i am using the ALTERA NIOSII CYCLONE kit ... here is the link for SLS corporation which has the ACCESSING MEMORY project under the quatus 5 section..plz find it at the end of the page... http://www.slscorp.com/up3support/pages/documents.php (http://www.slscorp.com/up3support/pages/documents.php) plz help me out....byeeeeeeee
