Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
20 years ago

prob. in accessing UART

Hello ... i have written the following prog. to access my uart in my design it is named as "uart_0" in the SOPC builder.... while running this prog. in NIOSII IDE i was simulataneously running...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
20 years ago

->NIOSII IDE to run the code in CYCLONE KIT

is this a development board from Altera?

->using the project "ACCESSING MEMORY" present in SLS corporation site

I am not familiar with sls corporation. If you give a link to their webpage I can check on the project you mentioned.

--wolf