Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
8 years ago

NIOS II/f altera_avalon_i2c, possible BUG in HAL

Hi, I need a I2C master for my NIOS II/f. I thought using the I2C master which is shipped by Altera in Quartus Prime 17.0 should serve my needs. However I'm a bit worried about the software q...
Mosari's avatar
Mosari
Icon for New Contributor rankNew Contributor
2 years ago

Thank You report this.

I could SCL drive 400k.

but Is it collect which using I2C Master API ?


I wrote cfg speed set secont argument "400000".

But I couldn't drive 400k.

So Google it and got this report.

Why Intel doen't fix it.

Anyway. Thank you.

  • jmcguire3's avatar
    jmcguire3
    Icon for Occasional Contributor rankOccasional Contributor
    2 years ago

    Yes, this appears to be a bug in the HAL ... still ... after at least six years. I'm running an I2C bus on an Agilex part, and we added a peripheral that could run at 400kHz; we had previously been running the I2C bus at 200kHz without issue, though the generated clock looked like crap - duty cycle was nowhere near 50%.

    In the file drivers/src/intel_avalon_i2c.h we changed:

    //#define ALT_AVALON_I2C_DIFF_LCNT_HCNT 60
    #define ALT_AVALON_I2C_DIFF_LCNT_HCNT 30

    System runs fine at 100kHz, 200kHz and 400kHz now.

    Edit:

    Had better results dropping the ALT_AVALON_I2C_DIFF_LCNT_HCNT value to 10. Low-half of the SCL clock is right around 1us; high-half is nominally 1.4us.

    Scope traces are attached. One shows the system not-running with the way-too-skinny SCL clock - ALT_AVALON_I2C_DIFF_LCNT_HCNT set to 50. The other (which works) has the parameter set to 10.